c8.25 rear yoke replacement
#1
Seasoned Member
Thread Starter
Join Date: Mar 2012
Location: Glen Burnie, MD
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
c8.25 rear yoke replacement
I need to replace the yoke and nut on my 99 c8.25. Any suggestions on where to buy and what brand would be great.
#3
Senior Member
Join Date: Jun 2010
Location: riverside,ca
Posts: 566
Likes: 0
Received 1 Like
on
1 Post
Year: 2001
Model: Cherokee
Engine: 4.0L
Or you can drill out the bolt holes to 5/16 and replace the strap type u joint retainer to an actual u bolt type retainer...if that's the reason you need to replace it....that way its stronger and also, you won't have to setup a new crush sleeve or set up the pinion..
#4
Seasoned Member
Thread Starter
Join Date: Mar 2012
Location: Glen Burnie, MD
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Thanks for the suggestions. I am replacing just to replace. The nut and yoke is extremely rusty and the area where the u=joint goes looks pretty rough. I just bought the axle and am cleaning it up and prepping it to swap out my d35. What is involved with setting up the yoke? Is it not just a matter of swapping out with new parts?
#5
Seasoned Member
Thread Starter
Join Date: Mar 2012
Location: Glen Burnie, MD
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
ended up ordering the yoke from eastcoastgearsupply. was 120 shipped with u bolts, nut , and seal.
From reading I should be able to mark the nut and measure before removing and reinstall with locktite. this wiil keep me from messing with the crush sleeve.
anyone else done this
From reading I should be able to mark the nut and measure before removing and reinstall with locktite. this wiil keep me from messing with the crush sleeve.
anyone else done this
#6
CF Veteran
Join Date: Sep 2010
Location: Salt Lake City, UT
Posts: 4,968
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0L
ended up ordering the yoke from eastcoastgearsupply. was 120 shipped with u bolts, nut , and seal.
From reading I should be able to mark the nut and measure before removing and reinstall with locktite. this wiil keep me from messing with the crush sleeve.
anyone else done this
From reading I should be able to mark the nut and measure before removing and reinstall with locktite. this wiil keep me from messing with the crush sleeve.
anyone else done this
Thread
Thread Starter
Forum
Replies
Last Post
investinwaffles
Modified XJ Cherokee Tech
11
05-18-2021 12:02 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)