will these be to wide? i know i will have to trim some. anyone have pics or input ?

 

Well this should give you an idea. 33x12.5 r15x8 on a 3" lift, still have to trim

 

They will fit. Depending on what backspacing your rims have you may have to trim a little.

 

thanks for the quick reply. i like the looks of the 3 inch with 33s you happy with your set up?

 

Thanks!,and yea, I like it alot better than when i had my 31's. although i do need to do a little trimming. i was thinking that adj. lower control arms might fix that prob.

 

Here 4.5 lift 33x12.50 15x8 3.75bs rim

 

Not fully tucked yet but need more trimming, 4.5" RC with 33 MTRs. and sway bar still connected.

 

they will fit yes, but you will either rub when turning the wheel at full lock, or when flexing out on the trails if you dont trim. i ran this setup for awhile, hell with wheel spacers and no trimming i even rub at 6.5"s n 33s

 

i talked to him this morning and he said they have 5 inches of backspace with 0 offset. and he runs axle extenders on his TJ....it sounds like they wont work on mine

 

4" lift w/ 33x12.5x15 on 15x7s and 4" bs. Trimmed of course. Just got the new tires so I haven't flexed or bumpstopped to figure if it'll rub on the trails.

 

would the 5 inch b.s with a 0 offset work for my jeep? 15x10 inch rims

 

Estimated 4.5" of lift. I haven't measured it since I raised it from 3"
33X12.5X15 Duratracs on 15x8
I had to trim quite a bit but mostly because the PO didn't do it correctly when he put the flares on.