Wll this work for cutting fenders?

Reply Subscribe

Thread Tools

Search this Thread

Jul 25, 2011 | 09:27 PM

McIntosh

Thread Starter

Junior Member

Joined: Jul 2010

Posts: 55

Likes: 1

From: Ocean City

Year: 97

Model: Grand Cherokee

Engine: 4.0 I6

Wll this work for cutting fenders?

http://www.sears.com/shc/s/p_10153_1...1&blockType=G1

And some black trim lining from autozone

Jul 25, 2011 | 09:32 PM

xjheep92

CF Veteran

Joined: Nov 2008

Posts: 1,021

Likes: 3

From: mass

Year: 1992

Model: Cherokee

Engine: 4.0 high output

you would be better off getting an angle grinder instead
and buy a cut off wheel for it it will cost about the same and work much better. then use the auto zone trim and your good to go

Jul 25, 2011 | 10:54 PM

Bustedback

CF Veteran

Joined: Feb 2010

Posts: 12,367

Likes: 23

From: Oroville, CA

Year: 1995

Model: Grand Cherokee

Engine: 4.0 with all of the noise and clatter

A cut off wheel would work better without the possibility of warping the sheet metal because of a blade getting hung up.

Jul 25, 2011 | 11:00 PM

2door@halfdoors

Junior Member

Joined: May 2011

Posts: 62

Likes: 0

From: clearlake, ca

Year: 1996

Model: Cherokee

Engine: 4.0

a cut off wheel is deffintly the way to go

Jul 25, 2011 | 11:03 PM

Nickell586

Senior Member

Joined: Mar 2011

Posts: 956

Likes: 1

From: New Haven, IN

Year: 1998

Model: Cherokee

Engine: 4.0L

Cut off wheel just don't let it get away from you lol. I did that folding my rears ahhhh

Jul 26, 2011 | 12:21 AM

CatBassin

Senior Member

Joined: Jun 2011

Posts: 783

Likes: 0

Model: Cherokee

XJ fenders are very similar to a beer can so I agree with everyone else, cut-off wheel. I used one when I put my Bushwhackers on, worked a lot better than the sawz-all we were going to use.