What did you do to your Cherokee today?
CF Veteran
Joined: Jul 2010
Posts: 1,971
Likes: 5
From: WNY
Year: 1999
Model: Cherokee
Engine: 4.0 High Output
Took off the driver side tire and rim on my 98 and found out my pads and rotor were in decent shape, going to turn them and throw them back on after i get the axle.
Seasoned Member
Joined: Nov 2010
Posts: 448
Likes: 0
From: Youngsville, Louisiana
Well this is more of what i did this whole week. Took the old timing chain, and timing sprockets out, Also changed my oil and filter. Hooked up my new power steering pressure hose, put in the new ignition switch and started taking my old cracked grille off, took off my radiator. thats pretty much it, hopefully next week i get it started.
Can't wait to get home and work on my heep.
Senior Member
Joined: Apr 2009
Posts: 954
Likes: 2
From: New Waverly, Tx
Year: 1997
Model: Cherokee
Engine: Used engine just put in less than 79kmiles onit jeepersCreepers 60mm TB, '99-'01 intake, BorlaHeader
Junior Member
Joined: Nov 2010
Posts: 59
Likes: 0
From: Rochester NY
Year: 2000
Model: Cherokee
Engine: 4.0L
Scored a new axle with a Rustys offroad high steer kit and a arb locker. Ended up being the wrong gear set. Switched out the ring and pinion from my axle to the new one to find the arb locker has a broken $35 part and is also binding up. So ended up swapping everything back to stock axle. Started at 7pm and finished at 7am. All this work for a free axle all I had to do was cut out the welded spider gears on a xj and install unwelded spider gears.
Then when I got home to unload the axles my friend slid on the frosty grass into my shed and knocked over my 09 Suzuki DR-Z400
Then when I got home to unload the axles my friend slid on the frosty grass into my shed and knocked over my 09 Suzuki DR-Z400
Seasoned Member
Joined: Mar 2010
Posts: 388
Likes: 0
From: North, Ga
Year: 1995
Model: Grand Cherokee
Engine: 4.0
Seasoned Member
Joined: Mar 2010
Posts: 388
Likes: 0
From: North, Ga
Year: 1995
Model: Grand Cherokee
Engine: 4.0
I installed a new blower motor and got the heat to work in my Jeep today. Then I took her to the car wash for a good bath. Its been a while since she was this clean. I wanted her to look good for my date tonight.
Member
Joined: Jul 2010
Posts: 236
Likes: 0
From: Fort Worth, Texas
Year: 1998
Model: Cherokee
Engine: 242/4.0 I6
Seasoned Member
Joined: Sep 2010
Posts: 329
Likes: 0
From: Tallahassee, FL
Year: 1999
Model: Cherokee
Engine: 4.0L
just got a much needed vacuum and bath, replaced the rusty screws in the door sills, got new sylvania headlights (not silverstars) put in last night and new wiper blades all around. I'm about to go look into some wal-fart fog lights to go in the stock locations.