What did you do to your Cherokee today?
CF Veteran
Joined: Jul 2012
Posts: 4,104
Likes: 2
From: San Antonio, TX
Year: 1996
Model: Cherokee
Engine: 4.0L
gassed up, aired up, tore the old rubber bushings out of the long arms, new ruber and flex joint races waiting to go in as soon as the arms get a coat of paint
Senior Member
Joined: May 2014
Posts: 946
Likes: 0
From: Iroquois Ontario Canada
Year: 1998
Model: Cherokee
Engine: 4.0
Went and picked up a set of snow tires for my brother then crawled under it and pulled the NSS, cleaned and repaired the switch (fingers crossed). It was lots of fun pulling the switch with all the slush and water dripping off the under carriage.
Just waiting for a bit of epoxy to cure before putting the switch back together so I can re-install it. The bottom part of the plastic housing was broken out, about 1/8th of it, and I think that may have been part of my P0705/P0700 CEL. The switch wasn't too dirty, but the contacts were a little corroded. A quick buffing with some 2500 grit wet dry sand paper and all the contacts are shiny now. The crud was keeping the springs behind the arm contacts from applying any pressure too. I figure there was enough play due to the cracked housing, and the lack of spring pressure is what was setting off the code. Sometimes it was fine and others I couldn't clear the code at all.
A new NSS is in the near future and this is just a temporary fix to get me past the e-test without having to buy another temporary permit. Still makes no sense to me that a CEL for a transmission problem will cause an instant fail but it does
.
*UPDATE*
No joy, the P0705 is still there, but no CEL at this time.
Just waiting for a bit of epoxy to cure before putting the switch back together so I can re-install it. The bottom part of the plastic housing was broken out, about 1/8th of it, and I think that may have been part of my P0705/P0700 CEL. The switch wasn't too dirty, but the contacts were a little corroded. A quick buffing with some 2500 grit wet dry sand paper and all the contacts are shiny now. The crud was keeping the springs behind the arm contacts from applying any pressure too. I figure there was enough play due to the cracked housing, and the lack of spring pressure is what was setting off the code. Sometimes it was fine and others I couldn't clear the code at all.
A new NSS is in the near future and this is just a temporary fix to get me past the e-test without having to buy another temporary permit. Still makes no sense to me that a CEL for a transmission problem will cause an instant fail but it does
.*UPDATE*
No joy, the P0705 is still there, but no CEL at this time.
Last edited by SG Mason; Dec 12, 2014 at 03:00 PM.
CF Veteran
Joined: May 2011
Posts: 6,098
Likes: 250
From: DE
Year: 1988
Model: Cherokee
Engine: I6 4.0
Drove back home from school for winter break. Also, I believe that my headlight switch is going bad. Headlights were flicking on and off randomly, just headlights, but thankfully it was just the last hour of the drive and I had my bright fogs on.
::CF Moderator::
Joined: Aug 2011
Posts: 43,971
Likes: 1,578
From: Prescott, Az
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
You know how to fix that, don't you?
Beach Bum
Joined: Jul 2011
Posts: 6,123
Likes: 22
From: Cape Hatteras, North Carolina
Year: 2000 WJ
Model: Grand Cherokee
Engine: 4.0
What are you doing tomorrow, Putco harness?
