What did you do to your Cherokee today?
Seasoned Member
Joined: Jul 2012
Posts: 269
Likes: 0
From: Loosiana
Year: 2001
Model: Cherokee
Engine: 4.0
I have an '01 and the HVAC controls are t4 10mm, And the transmission and 4x4 controls are 194's I think. There's a few threads on here about it. That's where I found out how to do it.
CF Veteran
Joined: Mar 2012
Posts: 1,414
Likes: 0
From: whiting
Year: 2001
Model: Cherokee
Engine: 4.0
Yea ive changed all my lights to leds besides the hvac controls and mine is a 01 as well so thanks for the info
Replaced right and left E-brake cables, front-to-rear brake lines/plumbing, muffler, tailpipe and all four shocks. Broke each rear shock stud and all four front bottom shock mount bolts (PITA). Saved rear shock studs by drilling stud centers and tapping-in new bolts. Troubleshot and repaired (for free) the cause for a code P1682 (Low Charge Voltage). Today I'll clean the K&N filter, throttle body and IAC, replace Cap/Rotor/Wires/Plugs. The rest of the week will be all about lubrication and fluids...
Senior Member
Joined: Aug 2012
Posts: 583
Likes: 0
From: Clear Lake, TX
Year: 1999 Jeep Cherokee
Model: Cherokee
Engine: 4.0
Finished the front and rear locker install and front wheel hub assembly.
Discovered one set of the carrier bearings were bad on the front, so I changed them out. Pic does not reflect how pitted some of the bearings were.
Vatozone decided to send me home with the wrong front wheel hub assembly. I did not notice until both fronts were installed and wheels on. 3/16" too short causing the rotor to jam into the spindle. So, today I pulled the wheels, rotors, and hubs back off.
Went back to Vatozone and they got the part number right this time so now all it good.
Discovered one set of the carrier bearings were bad on the front, so I changed them out. Pic does not reflect how pitted some of the bearings were.
Vatozone decided to send me home with the wrong front wheel hub assembly. I did not notice until both fronts were installed and wheels on. 3/16" too short causing the rotor to jam into the spindle. So, today I pulled the wheels, rotors, and hubs back off.
Went back to Vatozone and they got the part number right this time so now all it good.
Seasoned Member
Joined: Jul 2011
Posts: 447
Likes: 0
From: Alliance, Ohio
Year: 1999
Model: Cherokee
Engine: 4.0
In the course of the weekend she got a ton of love. New plugs,wires,cap,rotor,o2 sensor on h4 conversion on the headlights. Oh,and my girlfriend painted her d rings. Just point me to the mall now. Lol





