tomorrow i´ll take some pics of the small bender i used for the corners.
because the one one i used for the large bumper is huge and in a special shop. but were should i upload the pics??

 

Found a washer fluid bottle and some other garbage at the local pick and pull. Finally got around to changing wipers. Its the little things,LOL.

 

Took my front tires to Discount Tire today to have all the mud cleaned out of them and have them remounted. They spent over an hour cleaning all the mud out of the one I rolled off of the rim last month. They wrote the ticket up as 2 flat repairs and did not charhge me a single penny.

 

Took her out in the great Northern Virginia blizzard today... 20" or so, which is a LOT for us! Pulled out a late model Toyota Tacoma from the ditch around noon - first time I had a chance to really use my JCR bumper!

Only bad part - broke my rear window wiper sweeping snow off.. Crud!

Still, a great day. I love my Jeep - even bone stock, she plows through snow like a champ!

 

wired my trailer lights

 

drove through some snow, and changed the oil to ready it up for a trip to wisconsin on monday

 

i almost finished my bumper

 

I had my oil changed to Castrol 20w-50 High Mileage and got rid of all my engine noise and brought my oil pressure guage back up.

 

cleaned all the junk out of it..omg to bags of trash !!!!

 

Rigged up my power seats. Now they work!!!

 

Im Freeeezing ! lol . Bought some nylon and made a washer with a half inch hole to put in my rad hose hoping it would cure my low heat, temp gauge yoyoing problem, specially now the snows arrived, it worked to an extent but not enough, i will try again with a smaller hole - scary though ! for tmrw ive wedged some cardboard in front of the rad !!

 

I installed 4 switches into the overhead console. One switch for the Arc lights and the rest for future use. I ran a dedicated, fused 12V supply, to the switches and used Cat-5 cable to feed the control voltage to the relays.

I am hoping to here from somebody with ideas that has tied an auxiliary similar to this into the door chime module so that I do not come back to a dead battery some time… I didn’t want to tie the relay distribution into the acc/run circuit because there are times I may want just these lights on.

 

Got in her to go to church this morning...gas light came on and I was out of time....all piled out and took the wife's van instead

 

Got the front seats and some of the trim out, getting ready for the install of the ZJ seats later this week/next weekend. Also getting ready to install the front skid, front D-rings, Tcase/Tranny/Oil pan skid and rocker rails next weekend.

 

Installed my new Iron Rock double-shear track bar. DW is officially GONE now, and I couldn't be happier.