Well that was a waist of a lot of good parts

 

Did you lose in CoD and get mad lol

 

Put a 97+ center console in my 94.

 

No, it's an original and I've had to replace the laser in it like 5 times and I got sick of fixing it. Every 100th time it would actually work then quit 10 minutes into playing. Most rage inducing **** ever and it needed to die.

 

Should've turned it into a computer. I gutted mine, wrote up plans for it, then bought a Jeep and all my money disappeared

 

Back into a jeep!!

 

Did the cut and fold on the rear quarter panels got to finish it up another day

 

Bed lined the lower 1/4 all the way around. Started with the Rustoleum and that **** is garbage. Ran like paint and not thick at all. Switched to Duplicolor and that stuff rocks. Thick rubbery and does not run or drip.

Not worried about the over spray. I'm going to get it painted desert tan in the next few weeks. I just wanted clean lines along the edge.

Next is new headliner from JC Whitney, supposed to be here tomorrow. Then it will be bumpers and then seats.

 

LOL! ^^ That overspray is kinda funny... At least your getting it painted. Not gonna trim the fenders anymore?

 

My son's XJ has heater problems. I replaced the resistor but still no heat. I can jump the blower and it works fine. I do NOT have different voltages at the motor harness as I cycle through the blower fan speed switch.

any ideas?

 

I like your rims.

 

Thanks. Not too many all black in 18" that I could find.


I am at some point. I figured the bedliner will cut easy enough so no big deal when I do.

 

lol

 

finally riveted a half of aluminum sheet on my drivers door on bottom to cover big rust hole,which was under that rubber moulding. when finished gonna flex seal it. until i can put my rust free doors on,hopefully next summer,maybe.

 

Took it all apart