3.52 Costco In Bountiful Utah

 

No u shouldn't, its what they send with the kits, factory tre will work

 

Just looked at it waiting for tomorrow so I can go get the ccv kit and work on the jeep again!

 

Just ordered a iron rock offroad doable shear track bar for my big xj

 

Today I put on my new hella 500's finally.. I did it all wrong, I put on the housings before I put on the grill again, then i messed up the little rubber seal things... And then while trying to put in the light to the housing I dropped it causing it to now have two cracks going down the glass.. I don't k ow if i should, yet again, buy another pair. Or just leave it. I mean they have 100w bulbs and are super bright, even though I need to align them, but the one just looks gross... :/ orrrrrr I have an older housing, bu the bulb doesn't fit perfectly since it's an older housing and then I'd hqve two different looking housings. Gahhhhh it was just a bitter sweet day :/

 

finally found my massive vacuum leak... the dumbass previous owner who replaced the entire electrical, and vacuum systems and also replaced every sensor on the damn thing didnt tighten up the IAC..... dumbass but damn its nice to have a jeep with no electrical or vacuum issies at all

 

Dropped front and rear bumpers off at bed lining today. Hopefully have them back tomorrow

 

Got some mud on the tires.... And just about everywhere else too.

 

Started my front locker install......And yes, with 3.55 gears you have to pull the carrier.

 

How's that going man? I'm going to be getting a rear locker pretty soon..

 

Um don't you have to pull the carrier with any gear ratio?

 

For a lunchbox locker up front, yea(d30)

But for the back, no

 

You don't always have to pull the carrier the install a lunchbox locker. You obviously have to pull both shafts but it's quite simple.

 

Pretty good actually for an indiana vehicle.

I read that for some you don't have to.

 

I took the intake in to be hot tanked, and maybe blasted.