so yesterday i was adding a 3 in. lift and had a leaf spring bolt freeze inside the bushing.... well i got out the trusty tourch and began heating up the sleeve to expand it and pull the bolt out. half way through i notice something drip, i look up and the inside of my jeep is full of smoke. luckly i always have a fire extinguisher inside my jeep. turns out i had a little rust hole i never knew about and that caught some carpet under the seat on fire and burned a little of the bottom of the seat and melter a little of the side panel where the cup holder is.......
its an 89 2 dr.

I did get the lift on.....

now onto my question after that rather embarrassing part. what can i do with the back seat. any ideas?
I could go to a junk yard and get a new one and a panel.
or i can just take the seat out and start a new project.

 

93-98 Grand cherokee 60/40 rear bench

 

i thought that wouldn't work on pre 95 cherokees

 

The fronts don't unless you fab some brackets. The rear will work in any year xj. Check the link in my signature. It's a decent amount if work, but worth it imo.

 

i had seen your fab before, just didnt know if it was different for the renix. and im going to a jy here pretty soon, ill check them out. I cant just take the brackets off my front seats and put them on a zj seat too?

 

Two bucket seats.

 

JY or E-bay Or find someone parting out an XJ.

 

i know i can put seats back in, but i do not have kids, only a dog and my fiance. we have her car if we need a back seat. i can do anything, what is useful besides just making it flat?