Jon Boat on XJ
#1
Member
Thread Starter
Join Date: Jan 2010
Location: Bradenton FL
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
Jon Boat on XJ
I have a 10ft Jon Boat that I want to put on my XJ
has anyone ever done this before?
If yes then how, anything especial?
has anyone ever done this before?
If yes then how, anything especial?
#2
Member
Thread Starter
Join Date: Jan 2010
Location: Bradenton FL
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
Fishing Boat
Has anyone put a 10ft boat on top on an XJ?
I had mine inside with half sticking out, its okay but I want to be able to close the door.
Besides a trailer is there another way?
I had mine inside with half sticking out, its okay but I want to be able to close the door.
Besides a trailer is there another way?
#3
Junior Member
Join Date: Apr 2009
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
got roof racks? if so bottom DOWN other wise it will slider around and beat the **** out of you roof... figured it out the hard way. and ratchet straps around an tie it down to front and rear bumper! i did it with a 14'. make sure its tight and re tighten it a few miles down the road.
#5
Senior Member
Join Date: Oct 2009
Location: Sutton, New Hampshire
Posts: 633
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0L
If you've got the roof rails and cross-braces, you can put it up there and just secure it down at the front and rear of the Jeep down near the fenders. That's what I do with my canoe. I added some tie-down rings to the front bumper so I could tie down there, and I have my hitch in the back. My canoe is a 12-footer, so your boat should fit so long as it's not wider than the Cherokee.
#7
Senior Member
Join Date: Feb 2009
Location: Birmingham, Alabama
Posts: 565
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
i turn mine upside down bow forward...... open rear doors and run ratchet strap over boat thru cab, cinch down. One strap from front of boat to front bumper and one from rear handles on boat to rear bumper.
Ugly, but it isnt going anywhere that way.
Ugly, but it isnt going anywhere that way.
Trending Topics
#8
Honorary Moderator
Join Date: Mar 2010
Location: Gilbert AZ/Las Cruces NM
Posts: 8,135
Likes: 0
Received 13 Likes
on
11 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 upgraded
they way we tied ours down was ran 2 ratchet straps off of the front to the outter edges of the front bumper(near the mounting points) and hooked them on the under side lip. then did the same thing on the rear. Then we took a ratchet strap and looped them around each edge of the cross rails on the roof then up and over the boat and then did it to the other side so you have 2 off of the front then 2 around the main body so it cant twist side to side nor can it slide off.looks pretty too =]
#12
Senior Member
Join Date: Feb 2009
Location: delaware.milton
Posts: 676
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996-1997
Model: Cherokee
Engine: I-6,4.0-246000+miles
#13
Seasoned Member
Join Date: Dec 2008
Posts: 495
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1995
Model: Cherokee
Engine: 4.0L High Output
Nice Jeep boat tomcarey88! Haha. I load my canoe and kayaks on the factory rack all the time. It's getting a bit worn out though, I need some Thule or Yakima load bars up there. I run it like this:
I just got a couple of pool noodles and sliced them lengthways and cut them to fit the bars. Then I use two ratchet straps to secure the canoe. I often run a line front and rear, although the ratche straps are so tight that it's not needed, that suckers not going anywhere. I also load my friends 10' Smokercraft jonboat the same way, except we load it right side up.
That's a 14' canoe BTW.
I just got a couple of pool noodles and sliced them lengthways and cut them to fit the bars. Then I use two ratchet straps to secure the canoe. I often run a line front and rear, although the ratche straps are so tight that it's not needed, that suckers not going anywhere. I also load my friends 10' Smokercraft jonboat the same way, except we load it right side up.
That's a 14' canoe BTW.
#14
Member
Thread Starter
Join Date: Jan 2010
Location: Bradenton FL
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
Thats some nice Pics
Thats what I want to see!!
As for two threads , I wasnt sure if I should place on here or not
Thats what I want to see!!
As for two threads , I wasnt sure if I should place on here or not
Thread
Thread Starter
Forum
Replies
Last Post
jurazov
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
12
07-20-2023 04:13 AM
Bruce Hauptman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
09-05-2015 09:31 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)