Been searching and was wondering if anyone knew where a how to was to remove the intake and exhaust manifold so i can put a new gasket on... I started it and im stuck..... Any help would be appreciated

 

What are you stuck with?

 

Remove belt, remove powersteering pump, remove intake tube and air box, disconnect cables from throttle body, disconnect all vacuum lines , disconnect electric connections at throttle body,disconnect fuel line and bolt that holds the line on, undo all Injector connections, remove the 4 bolts under the intake manifold, remove the 4 on top, pull off intake manifold, unholy the exhaust flange from the header, remove the 2 remaining header nuts and header bolt, clean surface, apply gasket. Reverse to install

 

thanks guys i ended up missing one one of the bottom header bolts i finally got it put back together and i think my header is cracked so prob gonna tear back into it again wish i would of known before..