Help
#4
Seasoned Member
Join Date: Aug 2013
Location: Duluth, MN
Posts: 452
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1999
Model: Cherokee
Engine: 4.0 I6
Check all fuses.
Check all grounds related to battery.
Make sure battery cables/terminals are clean and free of corrosion.
If all of these check out the most likely culprit is the CPS. If that's the case do yourself a favor and get a factory mopar replacement. Basically the same price and it will last a lot longer.
Check all grounds related to battery.
Make sure battery cables/terminals are clean and free of corrosion.
If all of these check out the most likely culprit is the CPS. If that's the case do yourself a favor and get a factory mopar replacement. Basically the same price and it will last a lot longer.
#6
Seasoned Member
Join Date: Nov 2013
Location: Boston
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0 Litre
#7
CF Veteran
Join Date: Aug 2011
Location: Blue Springs, MO
Posts: 1,031
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1993
Model: Grand Cherokee
Engine: 4.0L Laredo
No, it may prevent it running, but it won't prevent the starter from spinning the engine. Jeeps have what's called a neutral safety switch (NSS) that often go bad. Try starting it in neutral or wiggling the shifter a bit while trying to start it. You can also 'hot wire' the starter solenoid. Shorting the solenoid with say, a screwdriver or a remote starter switch will bypass the NSS. If you're unfamiliar with this method, be careful, it might just start up (if the key is in the run position) or at least spin the engine if it's not. The NSS can often be taken apart and cleaned if that's the problem. Good luck!