Anyone out there with a hack n tap sye? I have an np242 and I'm debating the $550 for a Tom Woods kit or to shoot for the $200 hack and tap iron rock kit with a referb shaft. I've read about the differences between the two but haven't talked to anyone who's done the kits. What's the word guys?

 

I have the 242 t case and run the hack n tap, my other buddy has the IRO 6.5 long arm on 35's with the hack n tap and I also installed it on a np231 so be saying I have it on 3 jeeps I think it's worth the money and 200 is pretty cheap for a SYE and driveshaft so go with it

 

Hey what did you use to cut those shafts? Did you pull those units in order to get em drilled center? Any tips?

 

Search around. Tons of info....

Take off both drive shafts, put it in reverse, use angle grinder. It will act like a lathe.

Then, iirc, put it in a forward gear for the drilling, just not while the motor is running. Thag way it stays in place.