Gauge issues
#1
Gauge issues
I reset my ecu a while back by unplugging the ground on the battery for about 30 minutes and before then my speedo and everything else worked as it should, after I reattached the ground all the gauges takes a few minutes to start working and now my tach will work for a second then drop to 0 while the jeep is idling. Any ideas how to fix it or what could be wrong?
#2
Senior Member
Join Date: Feb 2012
Location: Colorado Springs
Posts: 632
Likes: 0
Received 168 Likes
on
90 Posts
Year: 1989
Model: Cherokee
Engine: I6 4.0
I always read that you held the pos to the neg for 30 seconds then flashed the lights 3 times to reset the ecu. But that could be just older models. As for the tach, unplug clean and di-electric grease the connecter coming off the rotor. They are notorious for going bad. If that doesn't work, check your connection on the dash. Otherwise that connector is prob bad.
Thread
Thread Starter
Forum
Replies
Last Post
shelby5041
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
11-07-2015 01:22 AM
Chick-N-Picker
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-07-2015 07:56 PM
sikkev
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-05-2015 11:33 PM
Gauge
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
15
09-05-2015 11:02 PM
Montana5991
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-02-2015 09:23 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)