I have d30 and c8.25 axles what would be my wheeling limit if I ran 35's?

 

When something breaks, I'd say you found your limit.

 

x2 When the water is higher then your intake and when you tip over.

 

Id run 33s comfortably, 35s would be max id say..i have the same combo you do and will be running 35x12.50.17s within a week or so. I thnk the axles will be fine. If they were locked then I would be nervous.

 

A d35 can easily handle 37's. So you'll be fine. :/

 

lulz

 

Heres the thread i just started. It has a little info in it about runnin 35's on stock axles. https://www.cherokeeforum.com/f59/wh...1-tons-161872/

 

if the d30 is unlocked u will be fine if u treat her OK. IF the D30 is locked, buy some extra shafts and u joints. The rear end, youll be fine if its locked or unlocked just dont catch any fat air

 

I run 35s on the same set up. Locked 30 and open 8.25. Haven't had problems. Put them on when stuff breaks upgrade it. Also I think being locked is better for not breaking stuff. You can crawl and not have to roll into things.

 

How about on a 4.5 lift?

 

100% doable. trim and bumpstop as needed

 

Can somebody show me some pictures?

 

https://www.cherokeeforum.com/f59/xj...up-thread-260/

 

I don't know if I want to pull the trigger on 35's now at 4.5 or wait and boost it up to 6..

 

4.5 and 35s.. Im doing it, matter of fact im picking up my 35s this weekend and im only on like 3 inches right now. So they are gonna have to fit on 3 inches until the end of the month when I go to 4.5