how is it bolted on? are you going to be adding and tow points? are you planning on just mounting a winch right on top?

 

Looks good dude.

 

I also made some brackets from the same 1/4 inch plating to bolt six screws. On to the frame ..plus 5 more in the middle of the back of the bumper

 

Oh and yeah the winch will sit in the middle bolted down ..also adding a stinger and covering the bumper in linex or linax whatever its called

 

it does look pretty decent and stout

 

And I will also be adding d rings at the front bottom of my bumper welded to the bottom 1/4 inch metal strip that will be welded under neath the bumper that I mentioned earlier

 

not bad...not bad at all. I like it. How bout a pic standing back showing the entire Jeep with it mounted

 

Ill post one in a bit ..

 

Here is another one I found ..ill post some of the full Jeep today

 

Looks good, and I can imagine it is a bit lighter than the usual full heavy steal bumpers... can't wait to see what it looks like once you get everything done with it..

 

Thanks man it is pretty light yet sturdy..I don't know if I should go flat black or black with line x..what do u think?

 

flat black means easy touch up for chips and scrapes caused by rocks, where as line x means no chips or scrapes. Personally, I say powder coat it flat black.

 

Looks pretty good. How far did the suspension sag when you got done?

 

Actually none at all ..I can drive better in windy conditions
And my Jeep was already a bit lower from the front but ill be installing a 1.25 spacer in the front.

 

I think it looks pretty good the only thing I would be concerned with is the approach angle on the corners for the tires. Might want to think about cutting the ends at a angle to help with that but like I said looks good man.

CJ