what would I use for a threaded shank for an adjustable LCA?

these would be short arms

planning to use OEM bushing, and plan to put a threaded shank in the middle that threads into 2" OD DOM tubing and has jam nuts on both sides


would a 1" thread shank be enough? or even a 3/4"?

 

I would check on Clayton
http://claytonoffroad.com/index.php/cPath/18_79
http://claytonoffroad.com/index.php/...sort/2a/page/2

If that's not what you are looking for then try Ballistic Fabrication
http://www.ballisticfabrication.com/...pters_c_7.html
If you still haven't found it on one of these sites then I guess I don't know what you want..

 

You can get away with 1 1/4" .156 wall DOM tubing. That will thread a 1" Johnny joint.

 

You could do like i made mine have your control arm cut in half and add bungs to it and add a piece like a tie rode so you can adjust control arms in or out but one thread has to be right handed and the other left so it will either push or pull

 

^ you only want one heim joint per control arm. You will have too much deflection and they will prematurely wear out. Go with a solid mount on the axle through a bushing, and a Johnny joint on the frame mount side.

 

Lol this thread cracks me up... dangerous rides in here...

 

good thing I dropped the idea