I have a almost new set of RE super/flex control arms but they are not adjustable. I was wondering if anybody knew the tubing size so I could just cut them and install threaded tube adapters?? Is this possible? Any ideas would be awesome. I can weld and have some fab skills. I just don't want to spend more cash on adjustables when these arms are good. Thanks

 

ballistic fab's has the tube inserts pretty cheap and several sizes... most i think are for 1.75in inside diameter...

 

Yeah thats were I was looking. I will have to buy a caliper to measure the pipe diameter then order then up.

 

Once you cut them you will need to get the burrs out and make an inside measurement with a caliper to get exact numbers.

 

RE sells the the threaded inserts on their site. You can simply cut one end off, add the threaded insert, then buy an adjustable builder end.