did a little dash rearranging last night

 

NEAT !

 

Cool, do you have any more detail on how you did that?

 

not alot. i was kinda hammered. it does invole some cutting and removal of the defrost flap. it is actually mounted in the heater ducting

 

I thought about doing that because you can't run a flip up monitor in the stock location but I didn't want to lose that vent. You aughta install a shelf pocket in that blank space.

 

i think it will make a nice spot for some switches

 

That works too

 

I cut my defrost flap. Man I regret it

Nice work though

 

how hard was it??? cause ima do that or build a adapter outa sheetmetal to extend and support a flipout so it fits in the factory spot

 

it wasnt bad

 

I have the same flip out in my cherokee. But all I did was move the heater/ac controls up in the radio din like in his picture. And installed the flip out in the din right below it. That way I still have my vent at the bottom and didn't have to cut any flap or cut into my airduct. The flip out works just fine...it comes all the way out. It just hides the controls for the heat and a/c but if I want to adjust them I just retract the screen back in make my adjustments and flip the screen back out.

 

That looks, but you said you had to cut the defroster flap....how does that affect your windshield defroster?

 

When I cut my flap the defrost don't work. It just blows out the dash vent lol sucks now that it's snowing. That's why I regret cutting mine lol

 

mine still blows out the defrost. and the vents at the same time. can switch between the 2

 

How did you get that to happen. I cut the whole flap out and while it still blows very very lightly out the defrost most of the air comes from vents and while
I can switch between the two since there is no flap to close the vents off all the air still comes from vents.