Well, turn signals and flashers stopped working.

fuses are not blown....

the switch dead?

If its the switch, thats alright becuz I just bought fog lites and want to switc it over.

Anyone done that on here?
how hard is it to do the wiring for the fogs?

 

I'd check/replace the flasher for the ts's and hazard's. IMO
Dan

 

Yep, as stated check the flasher first. For the fog lights you can use this example. This one would be separate from the factory install. You can substitute a lighted switch for the indicator light.

Fog Lights

 

Thanks ol blue and ETjeep
I will have to run to the stealership i the morning.

ET
I want to use the factory setup if at all possible...but if it comes to doing my own, that will be the ticket. tanks again!

 

If you need the wiring diagram for the factory setup let me know and I will send them. Let me know which vehicle and model. PM me an email address. I will see what I have and sent it to you.

 

took me 10 mins to take out the flasher from my other GC and slap in my wifes.
thanks for the info on this. I had to drive to Indy from nothern Indiana and was dredding to srive there with no signals.

My wife and I flew out today to Alabama to get her a 04 laredo that is essentially a Limited without the dual climate. Driving it home tomorrow!

 

Congrats on getting another Jeep! Post up some pics when you can.
Dan