I am trying to replace the engine in a 1995 Jeep Grand Cherokee Limited 4WD auto transmission with a 5.2 L V-8 engine. I am working on removing the power steering pump and cannot get the last bolt out. It is the one on the top back side of the pump that there doesn't seem to be any way to get any kind of a wrench on that will then turn. No way to get a socket or closed end wrench on it at all. I can get a straight box end wrench on it but then there is no room to turn it - not even a little. It looks like if you could get the reservoir off, you might be able to get to it. But I can't get the clips off with it mounted on the engine. Any ideas would be greatly appreciated.

 

I am not being a butt. you will probably get a better response in the grand cherokee area of this forum. this is the stock xj section.

good luck,
happy jeepin

texastaz38

 

Line up the holes on the pulley with the bolts.