Quick control arm question
#1
Member
Thread Starter
Join Date: Oct 2010
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I've been "searching" and heard the wj lower control arms were a little bit longer then the stock zj's. Then on another thread they said they were bigger but the length between the holes were the same it just the arms beefy-er and make a better ride. Any one know the correct answer ?
Last edited by morando6784; 03-04-2011 at 11:31 AM.
#2
Member
Join Date: Jul 2009
Location: Fort Collins, CO
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98
Model: Grand Cherokee
Engine: 4.0
JK control arms
From what I remember reading these are not a direct swap and you need new brackets to make them work.
I used some rear upper JK control arms to replace my lowers on my ZJ. I measured them to be 3/4" longer. The ends are a little bit narrower so I used some washers to take any slop outs. I have only replaced my rears at this time but have another set in the garage to swap out the front lower control arms as well.
I used some rear upper JK control arms to replace my lowers on my ZJ. I measured them to be 3/4" longer. The ends are a little bit narrower so I used some washers to take any slop outs. I have only replaced my rears at this time but have another set in the garage to swap out the front lower control arms as well.
Thread
Thread Starter
Forum
Replies
Last Post
nicksan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
28
03-08-2016 11:33 AM
JPXJMOAB
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
09-06-2015 07:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)