'95 Grand Cherokee, 5.2, have this part left after replacing oil pan gasket and rear main seal. Had to drop exhaust, removing crossmember under transmission. Also, replaced master cylinder and brake power booster, disconnected brake pedal under dash, and flushed/bled brakes. Had the washer reservoir out and the exhaust manifold heat shield on the passenger side out as well. Replaced sway bar links and bushings. Just can't figure out where this sheet metal bracket would go.

Paul

 

One oilpan bolt holds it to pan, then it holds the 02 sensor harness..

 

Or it might brace/hold the transmission fluid line..

 

That's what I was thinking. One of the bolts on the pan has a threaded stud integral to it. I don't remember where it was on the pan, but when I put the pan back on, I attached the strap that was around the transmission lines to it. There was something about the orientation of the strap that didn't seem quite right. Maybe that bracket was the missing link. Thanks for the reply.