Do I need to!
#1
Do I need to!
I have a 04 WJ 4.0 special edition 126k miles. Im getting ready to replace my ball joints (upper and lower) Im also doing my wheel hub bearings. Should I go ahead and replace my front axles at the same time or is that a part thats not problematic.
#2
Old fart with a wrench
I'm assuming these are CV axles? As long as the boots are not cracked and leaking grease or making noise, I think you can wait until they are a problem. Once one becomes a problem, then replace both. JMHO.
#3
Member
Join Date: Jun 2012
Location: Yamhill county, Oregon
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0L
what dave said, no need to fix them until they break, and of course when one goes do both. Also why your at it down there i would check your tie rod ends and controll arm bushings. if theres any sign of wear i would replace them as well.
If you end up needing a control arm bushing i would go ahead and do them all, and while you're at it i would upgrade to poly bushings.
If you end up needing a control arm bushing i would go ahead and do them all, and while you're at it i would upgrade to poly bushings.
Last edited by wheelerboy12; 08-30-2013 at 06:10 PM.