Control arm bushings JUNK
12-27-2010, 03:10 PM
#1
CF Veteran
Thread Starter
Join Date: May 2010
Location: New Hampshire
Posts: 1,013
Likes: 0
Received 1 Like
on
1 Post
Year: 1997
Model: Grand Cherokee
Engine: 4.0
Control arm bushings JUNK
I have to replace control arm bushings on my 97JGC. The rear are rotted and the fronts are cracking. Anyone use the energy suspension parts for these? Are they tough to install? Wish I could find a decent set of control arms for a lifted JGC for decent cash
12-27-2010, 09:50 PM
#2
CF Veteran
Join Date: Feb 2010
Location: Oroville, CA
Posts: 12,367
Likes: 0
Received 19 Likes
on
18 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 with all of the noise and clatter
I replaced the arms on my 95 GC instead of screwing around with pressing the old bushings and risk damaging the arms. www.quadratec.com and ebay had my arms.
12-27-2010, 09:59 PM
#3
CF Veteran
Join Date: Mar 2008
Location: Florence SC
Posts: 2,266
Likes: 0
Received 8 Likes
on
3 Posts
Year: 1996
Engine: 4.0
i woudn't run a polly bushing, very little to no flex out of the joint. if you can swing some $$ pick up a set of good flex arms. RE, RC, Clayton, IOR, BSD ect and you'll be a lot happier the flex on the rig 2
Thread
Thread Starter
Forum
Replies
Last Post
lgrant
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
07-05-2022 12:19 AM
ROCKRIDGE 4WD
Vendor Showcase
0
09-15-2015 01:21 PM
JPXJMOAB
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
09-06-2015 07:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)