Any tips with brake line
#1
Member
Thread Starter
Any tips with brake line
HI I'm trying to replace my driver side brake line and I'm having a bit of a hard time, I was trying to use a regular 3/8 open wrench, but I feel like I was just stripping it, so I got a flare nut wrench and tried using the 10mm one but doesn't seem to fit as tight at the 3/8, so I went and bought a 3/8 flare nut wrench and now that I tried using it, I can get it around the stupid nut or brake line! What the heck am I doing wrong?! Anybody have an easy way to get that **** off??? 93 jeep grand v8 just in case anybody needed to know
#2
Old fart with a wrench
Okay, here's the deal. When you used the open end wrench, you made the tube fitting out-of-round. Now the flare nut wrench won't fit because the flare nut is misshapen. At this point visegrips will work. AND you'll need another flare nut, unless you are using premade lines. I would suggest using copper-nickel tubing because it's easy to work with and won't rust.
Thread
Thread Starter
Forum
Replies
Last Post
Calikingcrawler
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-07-2021 07:14 AM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
RickJames Bish
Modified XJ Cherokee Tech
5
09-02-2015 03:22 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)