So this is what's up. My jeep front passenger wheel will start the jeep to use the abs on dry clean roads. I just had the brakes redone and it wasn't doing it before. I'm not sure if there is a sensor going out or if maybe it's related to the brake job. Any ideas? Would it be safe to try and remove the abs system fuses? What can I do to fix this easily?

 

Pull the abs relay and fuse.

 

Hi, i have the same problem, i tok out abs fuse and relay (3 fuses and 2 relays). The front wheel still did brake in some situations, i then tok some hard breaks and the problem is (for now) gone. I will try to put back the ABS and see. But i will replace the breake pads and make sure everyting is clean and free for rust to see if that fix the problem.

 

Are those the ones located in the engine compartment?

 

on my car it was in the engine and behind passenger door