My stereo light wont light up and my radio doesnt pick up and radio stations, only fuzz. Does anyone know how to help me?

 

I'm not much on radios, but it could be the ground strap for the radio, or the antennae.
And Welcome to CF!

 

thanks man

 

I just bought this 95 grand cherokee, new to forum and jeep owner. Would like some help on replacing antennae.

Thanks

 

Welcome to CF. This is for a '97 Grand, hope it helps.

FIXED ANTENNA
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the right front inner fender liner. Refer
to Group 23 - Body for the procedures.
(3) Unscrew the antenna mast from the antenna
body (Fig. 17).
(4) Remove the antenna cap nut and adapter using
an antenna nut wrench (Special Tool C-4816) (Fig.
18).
(5) Lower the antenna body and cable assembly
through the fender far enough to access the antenna
body through the right front fender wheel housing
(Fig. 19).
(6) Remove the fuse access panel in the right cowl
side trim panel, and remove the push nut that
secures the trim panel to the junction block (Fig. 20.
(7) Remove the two screws that secure the right
cowl side trim panel to the front door opening trim
and remove the cowl side kick panel trim.
(8) Locate the antenna coaxial cable connector
near the junction block at the right cowl side panel.
Unplug the connector by pulling it apart while twisting
the metal connector halves (Fig. 21). Do not pull
on the cable.
(9) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel. Access the
grommet from inside the right front fender wheel
housing.
(10) Pull the coaxial cable out through the right
cowl side outer panel and remove the antenna body
and cable from the vehicle.
(11) Reverse the removal procedures to install.
Tighten the antenna cap nut to 7.9 N·m (70 in. lbs.).
Tighten the antenna mast to 3.3 N·m (30 in. lbs.).

POWER ANTENNA
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the right front inner fender liner. Refer
to Group 23 - Body for the procedures.
(3) Remove the antenna cap nut and escutcheon
using an antenna nut wrench (Special Tool C-4816)
(Fig. 22).
(4) Remove the fuse access panel in the right cowl
side trim panel, and remove the push nut that
secures the trim panel to the junction block (Fig. 20).
(5) Remove the two screws that secure the right
cowl side trim panel to the front door opening trim
and remove the cowl side kick panel trim.
(6) Locate the antenna coaxial cable connector
near the junction block at the right cowl side panel.
Unplug the connector by pulling it apart while twisting
the metal connector halves (Fig. 21). Do not pull
on the cable.
(7) Unplug the power antenna wire harness connector
from the junction block.
(8) Remove the antenna mounting bolts (Fig. 22).
(9) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel. Access the
grommet from inside the right front fender wheel housing.
(10) Pull the antenna wire harness and coaxial
cable out through the right cowl side outer panel and
remove the power antenna unit from the vehicle.
(11) Reverse the removal procedures to install.
Tighten the hardware as follows:
² Antenna cap nut - 7.9 N·m (70 in. lbs.)
² Antenna mounting bolts - 8.4 N·m (75 in. lbs.)