Quote:
They're not too bad. This was my most recent project with mine, of course there's no such thing a a bad welder, just a bad grinder.Originally Posted by 94XjSport94
Got a cheap *** HF MIG welder today. Playing with the flux core right now.
Quote:
They're not too bad. This was my most recent project with mine, of course there's no such thing a a bad welder, just a bad grinder.
True. I had some nice flux core welds.Originally Posted by bhennessee1
They're not too bad. This was my most recent project with mine, of course there's no such thing a a bad welder, just a bad grinder.
Frame stiffeners to build sliders off of I think. Or idk
Old School CF Moderator
Quote:
Cross over steeringOriginally Posted by 94XjSport94
Frame stiffeners to build sliders off of I think. Or idk
Looking at the BTF hi steer knuckle bracket. Don't see a downside to it other than that it's a bracket an not the knuckle but it looks very well made.
I'm gonna do:
Mid stiffners
Slider creation
Box that up sorta
Steering
Locker this fall
Should have enough cash to do stiffner slider combo after I scrap the 98
I'm gonna do:
Mid stiffners
Slider creation
Box that up sorta
Steering
Locker this fall
Should have enough cash to do stiffner slider combo after I scrap the 98
Old School CF Moderator
Quote:
Not bad.Originally Posted by 94XjSport94
So here is my skid plate:who welded that?
Quote:
Not bad.
who welded that?
StumpXJ. Cost me $50 and gas. It started out pretty then we clearanced it for the driveshaft to clear perfectly and to fit the case completely.Originally Posted by Xj88
Not bad.
who welded that?
Old School CF Moderator
Quote:
StumpXJ. Cost me $50 and gas. It started out pretty then we clearanced it for the driveshaft to clear perfectly and to fit the case completely.
Looks good.Originally Posted by 94XjSport94
StumpXJ. Cost me $50 and gas. It started out pretty then we clearanced it for the driveshaft to clear perfectly and to fit the case completely.
If Brian had a bender I'd have him whip me up one off my stock x member.
