short, sweet and, to the point.
03-04-2013, 10:02 PM
#1
Newbie
Thread Starter
Join Date: Mar 2013
Location: london, ky
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
short, sweet and, to the point.
Hello, my name's Tyler and i'm new here.
Basically, i've been ghosting on here for about a year so I figured I would post what few pics i have of my build...
This is the earliest pic i have of it...
A 91 sport 2door, 5speed hit in the front end. no bumper, grill or passenger side headlight bessel. busted back side glass.. Stole it for $200 dollars because it didn't run.
stabbed a knife in the fuel pump relay and it fired right up
anyway. i started changing all the filters, fuel pump, plugs and wires, coil, and distributor.
then, i started repairing the glass.
i figured it would end up busted again so i replaced it with a piece of lexin (sp?)
on a tight budget so it got a rattle-can-red paint job
wheeled it for a while like that
took a stump through the floor board which was already rusted so had to patch that..
safety first!
got happy with the grinder and did the door hinge cuts and cut fenders
put in some mossy oak carpet
made an EMT roof rack... fail
then, the slave cylinder crapped out
i then decided it was time for a change.. murder it out and JCR Do it yourself bumper..
33's at stock height
really needed a lift or bumpstops...
guess which route i went..
that's it for now. i know it's short, sweet and to the point but just a quick run down of what pics i do have of what i've done. I'm a 20yr old married dad working in construction so i rarely have time to work on the old beater much. will post more as it comes along.
if you have any questions just lmk.
stiffeners and sye are in the garage for when i get time.
Basically, i've been ghosting on here for about a year so I figured I would post what few pics i have of my build...
This is the earliest pic i have of it...
A 91 sport 2door, 5speed hit in the front end. no bumper, grill or passenger side headlight bessel. busted back side glass.. Stole it for $200 dollars because it didn't run.
stabbed a knife in the fuel pump relay and it fired right up
anyway. i started changing all the filters, fuel pump, plugs and wires, coil, and distributor.
then, i started repairing the glass.
i figured it would end up busted again so i replaced it with a piece of lexin (sp?)
on a tight budget so it got a rattle-can-red paint job
wheeled it for a while like that
took a stump through the floor board which was already rusted so had to patch that..
safety first!
got happy with the grinder and did the door hinge cuts and cut fenders
put in some mossy oak carpet
made an EMT roof rack... fail
then, the slave cylinder crapped out
i then decided it was time for a change.. murder it out and JCR Do it yourself bumper..
33's at stock height
really needed a lift or bumpstops...
guess which route i went..
that's it for now. i know it's short, sweet and to the point but just a quick run down of what pics i do have of what i've done. I'm a 20yr old married dad working in construction so i rarely have time to work on the old beater much. will post more as it comes along.
if you have any questions just lmk.
stiffeners and sye are in the garage for when i get time.
03-08-2013, 06:44 PM
#6
Newbie
Thread Starter
Join Date: Mar 2013
Location: london, ky
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
Got up yesterday to go riding but no brakes.. replaced all the rear hard lines. Was going to do a write up but it's pretty self explanatory when you get into it.
03-23-2013, 11:18 PM
#7
Newbie
Thread Starter
Join Date: Mar 2013
Location: london, ky
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
scored stock shackles, front sway bar mounts, and a hood for my other xj in trade for a case of beer. 
looking for a PTO cable to hook to the front axle so I can get my SYE and new rear shaft in.
played with the tractor today.
looking for a PTO cable to hook to the front axle so I can get my SYE and new rear shaft in.played with the tractor today.
Trending Topics
03-25-2013, 12:47 PM
#8
Newbie
Thread Starter
Join Date: Mar 2013
Location: london, ky
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
Drivers side door pins broke... replacing with grade 8 bolts.
Last edited by onmybucket; 03-25-2013 at 08:31 PM. Reason: didn't mean to post 3 pics.. stupid phone
Thread
Thread Starter
Forum
Replies
Last Post
LittleRed94
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
10-06-2015 08:09 PM
Freakn
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
52
10-04-2015 06:34 AM
Stabsthedrama
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
15
10-03-2015 05:46 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)