so went wheeling today with the 35s for first time. successful trip. jeep did amazing although i didnt push her too too hard. here are some pics.

 

how hard was it to do the doorless? and how do they sit now?

 

its a very easy mod as long as the door pins dont break. and i mean once you cut the door pin the door will never sit flush again with the stock door pins. but iv heard 3/8th bolts will bring it back to closing flush. iv yet to try that though.

 

i reallyyyy want doorless but i dont want them sagging

 

they will sag a tid bit and after wheeling with no doors they sag a little more then before.. i am going to look into using the 3/8th bolt mod and see how that works. look in the advanced cherokee section i beleive my thread is just called wheeling with no doors and there is alot of info posted up there about it.

 

as an fyi- i used grade 8 5/8 bolts for my doors and my drivers side opens and closes literally like factory..... its amazing. the passenger side however sits low no matter how i adjust it... its just a door and it still closes and seals fine but its just annoying for me haha.im gonna try another mod to my pass. side once i get my half doors done so i guess we will see if tht fixes any thing

 

which 8 did you swap out? the ones that legit hold the hinges?

 

nonono it is a "grade 8" "5/8" bolt haha

 

ohhh gotcha ok yea im gonna be doing that over the stock pins once i get a chance right now getting my new axles is my biggest priority

 

so after trading my stinger winch bumper for a set of built axles it was time to pick up a new winch bumper and a few other goodies i can toss on the jeep while im swapping the axles out. here is a pic of the new winch bumper and then a pic of 1 of the new goodies i purchased which i might be most excited to put on.

 

Why didn't stuff like that happen to me. I really want some built axles

 

haha it kinda just happened. buddy of mine wanted my bumper like no tomorrow and around here stingers are very very rare. and he buys n flips jeeps on the reg so when he got a jeep with these axles in it n he didnt need em he offered me em for my bumper and i jumped on it. should be gettin the axles late this week or early next week, i cant wait.

 

mounted.

 

Thats not that strong of a bumper if it only ties into factory bumper holes your bumper is going to rip off when you needs hard tug or winch it

 

he has tie in plates...still and i would cut the brush guard off but the bumper itself looks good