Well I only had time to really cut my flares next week. I'll do a little metal not to much trying to keep my stock flares and such











What you think not to much kept it suddleish?

 

Not bad man... I think it looks pretty good.

 

Looks good but flexing Im gonna rub sheet metal lol so that's next and bump stops lol

 

bump stops are great, that way you can keep your tire rolling at full flex. when i took my old jeep up to shamokin it didnt have bumpstops and i got stuck because back wheel fully flexed in the wheel well and since no lockers no tire spin, was trying to do a hill climb in two wheel drive that had like mounds on top of it and had to roll down bottom of hill and try again lol. then almost flipped going down the hill..she was a good jeep lol

 

Next think on my list is rust prevention crap and insulate the inside going to east wood picking up thermocoustic liner, rust converter, encapsulator and a few other goodies should be started in the next week and a half or so also gotta caulk the windshield, after that depending on time and funds will be picking up MONSTALINER. So pretty stoked also cut little more fender just a little

 

ok pulled back seat out to finish pulling out the rest of my carpet and found 3 more rust holes

however tom should finish cutting fenders tom and cutting try getting my rough country disconnects on

 

look at my build thread for a little thing i made to keep the discos up when u have them off, works good so they dont just flop around and get in the way. i just leave mine disco'ed all the time

 

so pasat 2 days [ut in my eastwoods thermocoustic sheets on my tranny hump and put in my new rough country disconnects and then painted my sway bar and got her new front bushings also forgot pics but cut my rear fenders a little more

 

New sticker!!!!!

 

slightly stoooopid!!!

 

hmmm those thermowhatchamaccallits look pretty neat. my leg always gets hot from it..jeeps down right now

 

There pretty good I need more tho like a lot lol

 

OK so I spent 160 bucks on more thermo coustic flooring, also got thermo type tape and rust encapsulator all from Eastwood and got two free shirts heck yes!!! So Thursday I'll be doubling up the floor on my trans hump sanding some surface rust and coating it with the encapsulator.....
Friday I'll be finishing up some of that along with installing a hitch tire receiver I may be buying fingers crossed also doin an oil change gonna pick up that zmaxx stuff well see how that goes...... stay tuned I'm stoked and so should you be

 

Oh yea forgot next big upgrades limited slip for my 8.25 and air intake maybe a throttle body, high flow cat and a new non crushed down pipe any brand suggestions???????

 

just buy mine lol. have a spare parts truck. full exhaust, 8.25 locked lol. but i like the flowmaster 44 for exhaust, sounds great.