PROJECT Diversion: '93 XJ Country
#1
Junior Member
Thread Starter
Join Date: Oct 2009
Location: Elk Grove, CA
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0L, PowerAid, AirAid, hi-flow Cat, Magnaflow
PROJECT Diversion: '93 XJ Country
At some point I need to get some pics to show progress. Not much to show now so we'll just go with what has been done so far ...
(1) Rebuilt the front suspension. New UCAs and LCAs, replaced front wheel bearings. No springs or lift yet. Wanted to see what I was working with.
(2) Temporarily removed front sway bar.
(3) Rebuilt rear suspension. Replaced all bushings but left springs alone.
(4) Off came the rear sway bar.
(5) New KYB shocks front and rear.
(6) Recovery points front and rear: Draw-Tite w/ "D" ring.
(7) Airaid intake.
(8) PowerAid Throttle body.
(9) MagnaFlow muffler.
All done in the garage laying on my back.
Just purchased and plans for the next stage:
(1) UpCountry Springs (1" lift) for front.
(2) New leaf Springs (2" lift) for rear.
(3) Bar Pin Eliminators front and rear.
(4) Remove fender flares, wheel well liners and front and rear bumpers. Clean up and rust-proof.
(5) Remove and repaint grill, headlight trim and roof rack.
(6) Fender trimming front and rear. Add edge trim after cutting and painting.
After all that, we'll see what it all looks like them move on to larger tires/wheels for the low COG rig I've been thinking of. Pics will be showing up soon from the start of the project and steps along the way.
(1) Rebuilt the front suspension. New UCAs and LCAs, replaced front wheel bearings. No springs or lift yet. Wanted to see what I was working with.
(2) Temporarily removed front sway bar.
(3) Rebuilt rear suspension. Replaced all bushings but left springs alone.
(4) Off came the rear sway bar.
(5) New KYB shocks front and rear.
(6) Recovery points front and rear: Draw-Tite w/ "D" ring.
(7) Airaid intake.
(8) PowerAid Throttle body.
(9) MagnaFlow muffler.
All done in the garage laying on my back.
Just purchased and plans for the next stage:
(1) UpCountry Springs (1" lift) for front.
(2) New leaf Springs (2" lift) for rear.
(3) Bar Pin Eliminators front and rear.
(4) Remove fender flares, wheel well liners and front and rear bumpers. Clean up and rust-proof.
(5) Remove and repaint grill, headlight trim and roof rack.
(6) Fender trimming front and rear. Add edge trim after cutting and painting.
After all that, we'll see what it all looks like them move on to larger tires/wheels for the low COG rig I've been thinking of. Pics will be showing up soon from the start of the project and steps along the way.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)