project 1988 Pioneer
#79
Junior Member
Thread Starter
Join Date: Sep 2010
Location: Rapid City,SD
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Engine: 4.0
well work continues slowly but it is getting done
here is the old wiring
here is the new wiring
the old engine is on the left and the new one on the right
I started putting in the new harness
mounting the relay box
mounting the computer
here are the connectors on the inside that are in the cherokee but not in the comanche
part of them are power windows, locks and some other things im not entirely sure what else there is
more to come later
here is the old wiring
here is the new wiring
the old engine is on the left and the new one on the right
I started putting in the new harness
mounting the relay box
mounting the computer
here are the connectors on the inside that are in the cherokee but not in the comanche
part of them are power windows, locks and some other things im not entirely sure what else there is
more to come later
#81
Junior Member
Thread Starter
Join Date: Sep 2010
Location: Rapid City,SD
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Engine: 4.0
well it has been a while since i have updated my build thread but work has continued, i finished up the engine swap with the hardest part being wiring up the rear tail lights. After I wired it up i have been working on it for a while. and after adding some rock rails I finally took it out
The only thing i really had problems with was the gearing was a little to high so crawling was difficult the clutch driving was a little hard. it also got mighty warm in the cab. the jeep did very well over all. so it was a good run.
The only thing i really had problems with was the gearing was a little to high so crawling was difficult the clutch driving was a little hard. it also got mighty warm in the cab. the jeep did very well over all. so it was a good run.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)