The Official RaceJeep
#151
Senior Member
Thread Starter
Join Date: Oct 2010
Location: West By God Virginia
Posts: 999
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1997
Model: Cherokee
Engine: 99 4.0
heres a look at my trans mods. I have the line pressure cable pulled all the way out, then tied off. This keeps the trans at full pressure and makes hard solid shifts everytime. hopefully making the trans have a decent service life.
#156
Senior Member
Thread Starter
Join Date: Oct 2010
Location: West By God Virginia
Posts: 999
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1997
Model: Cherokee
Engine: 99 4.0
LOL, yea, thanks. Its meant to just be temporary. I was headed to the track, and wasnt entirely sure if it would work properly. But now that its tried and tested, Ill be looking for a permanent solution.
#157
Senior Member
Thread Starter
Join Date: Oct 2010
Location: West By God Virginia
Posts: 999
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1997
Model: Cherokee
Engine: 99 4.0
After thinking about it a little, Im not really sure there is much to do but clean up the connectors and use some wire loom to hide it a bit.
#158
Junior Member
Really? Why not mount the switch somewhere that won't be an eye sore? The shifter would look fine there without it.
#162
Junior Member
#163
Senior Member
Thread Starter
Join Date: Oct 2010
Location: West By God Virginia
Posts: 999
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1997
Model: Cherokee
Engine: 99 4.0
I mean I guess I could mount it on the other side of the hand brake, but it needs to be in close proximity to the shifter. Im not going to try and reach around for it. It needs to be usable with my arm on the center console. Plus I dont have a dash to mount it too anyway...Ill probably just loom it like I said...we'll see
#164
Junior Member
I mean I guess I could mount it on the other side of the hand brake, but it needs to be in close proximity to the shifter. Im not going to try and reach around for it. It needs to be usable with my arm on the center console. Plus I dont have a dash to mount it too anyway...Ill probably just loom it like I said...we'll see