My 94 XJ build "Project Junk"
Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
Next I needed to do something about my track bar.
So here is the beginning of a new track bar.....


Yes I know its over kill but I am doing it anyways.

So here is the beginning of a new track bar.....


Yes I know its over kill but I am doing it anyways.

Last edited by jrw7072009; Dec 5, 2010 at 01:22 PM.
Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
Well its done, and it is still over kill but not as bad as I though it was going to be.
Here is a few shots of the bracket.


Its almose done here.

Nice haggard welds :roll2:
Here is a few shots of the bracket.


Its almose done here.

Nice haggard welds :roll2:
Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
And most recent mod is a custom bumper I built around the end of Nov 2010
I reinforced the cross member with some 3/16" steel plate I will take it down the sides of the frame rails. I also will be adding a receiver to the front.
Its far from done I still need to reinforce the frame and cut some of the cross member out but here it is so far.
I will cut off the area where my licence plate is screwed to, and plate over it with some more steel.

I reinforced the cross member with some 3/16" steel plate I will take it down the sides of the frame rails. I also will be adding a receiver to the front.
Its far from done I still need to reinforce the frame and cut some of the cross member out but here it is so far.
I will cut off the area where my licence plate is screwed to, and plate over it with some more steel.

Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
I just replaced the damaged fender with one off a Country.Here is a pics from the other side, you can still see the sport.
Last edited by jrw7072009; Dec 5, 2010 at 01:42 PM.
Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
Well my bumper is pretty much done.



I added the 2" receiver and plated it a bunch more on the cross member and unibody. I also added the Pro Comp slim line lights I bought a while back.



I added the 2" receiver and plated it a bunch more on the cross member and unibody. I also added the Pro Comp slim line lights I bought a while back.
Thread Starter
Member
Joined: Jun 2009
Posts: 105
Likes: 0
From: West Jordan Utah
Year: 1994
Model: Cherokee
Engine: 4.0
I also installed my CB and rewired my aux fan to a new rocker switch. Now I have my fan and lights on two switches and my ARB and pump on two other switches on both sides of my steering wheel.
Here is my switches and CB installed, the blue one is my lights and the green is my aux. fan

Here you can see my two red switches on the left for my ARB and other two on the right for the lights and fan...(sorry its a bad picture)
Here is my switches and CB installed, the blue one is my lights and the green is my aux. fan

Here you can see my two red switches on the left for my ARB and other two on the right for the lights and fan...(sorry its a bad picture)









