Jeep xj on 3/4 tons
Thread Starter
CF Veteran
Joined: May 2013
Posts: 1,018
Likes: 0
From: Toe Peek Ugh
Year: 1993
Model: Cherokee
Engine: 4.0 ho
Last edited by cholthauss; Apr 6, 2015 at 01:47 PM.
Thread Starter
CF Veteran
Joined: May 2013
Posts: 1,018
Likes: 0
From: Toe Peek Ugh
Year: 1993
Model: Cherokee
Engine: 4.0 ho
More wiring pulled just tryn to clean things up and making it nice and simple pretty sure I've pulled 50lbs of wiring in the past few months
CF Veteran
Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
After adding the traction bar, were there any adverse effects? Is there anything you would do differently? I have some serious axle wrap after my axle swap so a traction bar is needed but I just want know hear from someone experienced with it.
CF Veteran
Joined: Apr 2011
Posts: 14,553
Likes: 1
From: Carrollton, GA
Year: 1994
Model: Cherokee
Engine: Inline 6 4.0L High Output
I used the barnes kit and just rotated the axle bracket where it wasnt hanging down too terribly low. I built the shackle end off my t case skid. The hardest part about adding a traction bar is finding a place that doesn't hang down too low on the frame side. I have yet to be stuck on it, just smacked it a few good times and rolled through with the go pedal.
CF Veteran
Joined: Aug 2010
Posts: 1,220
Likes: 0
From: Greensboro
Year: 1992
Model: Cherokee
Engine: 4.0L
I used the barnes kit and just rotated the axle bracket where it wasnt hanging down too terribly low. I built the shackle end off my t case skid. The hardest part about adding a traction bar is finding a place that doesn't hang down too low on the frame side. I have yet to be stuck on it, just smacked it a few good times and rolled through with the go pedal.