96 zj jeep build hank
#2
About 2 years ago I started the rebuild since it had a brand new transmission, starter, alternator, and a tune up.
I began cutting off the old cross member and pulling and bending all the metal back to the way it was as much as I could:
Not too bad considering I've never done this kinda work before!
Luckily I found a red zj at pull a part to replace the driver side fender:
After getting a new header panel and a new front end kit it's starting to look like a jeep again!
After picking up a new bumper at pull a part I honestly don't think I've ever put it on
I began cutting off the old cross member and pulling and bending all the metal back to the way it was as much as I could:
Not too bad considering I've never done this kinda work before!
Luckily I found a red zj at pull a part to replace the driver side fender:
After getting a new header panel and a new front end kit it's starting to look like a jeep again!
After picking up a new bumper at pull a part I honestly don't think I've ever put it on
Last edited by moose27; 07-19-2013 at 12:07 AM.
#6
Trending Topics
#8
Thread
Thread Starter
Forum
Replies
Last Post
EBowen95
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
49
08-25-2015 08:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)