Hi everybody! My first Jeep is a 1991 XJ that I've had for about 3 or 4 weeks now. The body and interior are rough but the inline 6 high output motor is solid. We finally have a couple of parts Jeeps that my son and I are using. There is a 1988 XJ with a 6 inch Pro Comp lift that I am going to replace my current 2 inch lift with. I started today. Got the wheels off and got it up on jack stands. Started with the rear driver side. I sprayed PB Blaster on all the nuts and bolts last night to loosen up rust and let it sit overnight. I got the rear driver side leaf u bolts off and loosened up the front leaf bolt. I attempted to remove the bolt on the driver side rear leaf bracket and managed to break it. It was stuck and rusted pretty bad. I moved to the rear passenger side and got one u bolt nut off. I moved to another one and it is pretty stuck. It pops and turns a little but I decided to spray more PB Blaster on it and let it sit. I did all of this while it was windy and rainy. Then I took a break and the temperature dropped and it decided to snow. So I'm done for today. Utah must suck more than normal because the wind is blowing like crazy here in Idaho. You can see pics in my build album.