My name is cliff and I drive a stock 95 XJ im from Rockland county NY

 

Joe. Chester county pa. 96 base model Cherokee 4.5 rc lift stock bumpers with welded on d rings 33/12.50/15 , stock driveline

 

Yo! Greg from Easton, PA here.

 

jake from ferndale, md. not quite a noob, just a noob to this forum. heres the rig. it is definitely not done. waiting on taxes lol.

1987 Jeep Wagoneer Limited, 4.0L, AW4, NP231, (front) LP D30, (rear) D44

Has a 3 inch lift from a previous owner, also the detours backbone on the front. Lacking a winch, but luckily, with the stockish-ness of my rig, i havent gotten it that stuck...

 

Hi. I'm Marco. I live in NJ and just bought my first jeep over the weekend. I bought a Blk/Blk 2012 Laredo. Looking forward to modding, etc.

 

New to the forum from St.Marys County MD.
Name's Ryan, I do my work in a 97 XJ

 

Hi, Kris from Manchester NH. 1995 XJ sport-moss green pearl-no lift-235/75R15 dunlop radial rover AT's, alpine head unit w ipod cable, soundbar w MB Quart 6.5's in back. recently repainted front grille/trim/bumper, angry eyes, tinted rear taillights, walker muffler (came on it, flowmaster 40 soon).
Anyone else from the manchester nh area?

 

Joe from Pittsburgh. Just got a 2001 xj not sure ab lift, anyone know how to tell? Thinking about a 3"- 4". It's got 31x10.5 on it. So far, mainly been doing routine maintenance and changing all fluids when not working. Put Hella 500's on.

 

Chris from Suffolk county ny 96 xj with 4.5 RC n20 lift

 

You can measure from the center of the hub to the bottom of the flare (if stock flares). Stock meas. are 17.5" front and 17.0" rear. so any higher is your lift.

 

Good to know! thanks for the input! The only other problem I have that I don't know about is, why my drivers side would sit 1/4" to 1/2" lower than passenger. I would have thought bad coil or leaf, but its both front and back. Maybe the lift was installed wrong, gotta figure that out

 

You've got those reversed. The front is 17" rear is 17.5".

 

That happen sometimes for rigs that normally only carry on person to lean to the driver side. Check your coil spring isolators to make sure they're in good condition.

 

Thanks! I'll have to check that out tomorrow.

 

Tyler from Winsted, CT
New to the forum, as well as my jeep.
'99 XJ 5 speed stock except for tomken gas tank skid plate