Got my axle shaft back, and it's in

 

Everyone go follow Olympus off road we have amazing deals on all our products and some of the strongest and brightest

 

you still owe me a yoke by the way

 

We on our? You work for them?

 

He got picked on fb as a local rep. So yes "we".

 

Coolio. That's what I was assuming, but I wasn't sure.

 

The swap itself went well, but I had issues with the bolts for the crossmember. I had a hell of a time getting it off and when I did it wouldn't go back on. Not sure if it's bent or what, but to get it on I had to elongate 2 of the holes. As soon as I started driving it there was a driveline vibration similar to what happens when not having a SYE. I'm thinking the crossmember is crooked since I wallowed out the holes and it's causing the vibe.

At this point, I ordered a Rugged Ridge HD crossmember and it'll be here on Wed. I'm going to bolt that up using the 3 good bolts that are there(the 4th one broke off and I had to drill the bolt out. Drill bit went off center so when I retapped the hole it's not in the original spot and I'll have to modify the new crossmember for the last bolt) and also pull the rear driveshaft and drive it to try and isolate the problem. If there is no vibration without the rear driveshaft then I'll reinstall it and go from there.

 

Yea I do follow on Facebook, instagram for a giveaway

 

I'm not trying to be a dick, but you should write coherently when you're representing a business, using sentences with commas, periods, and capital letters and all that jazz.

 

You should write this way all the time but that's just me.

 

hahaha. agreed.

 

I know. I'm sorry I havent gotten it yet. What size is the nut for them? I plan to go to the junkyard with a very small supply of tools.

 

mmmm 1 1/4"

 

I thought it was 1 1/8"? Ill take both and find out. Ill try to do that this weekend.

 

d30 is 1 1/8".