ohio roll call
Originally Posted by LongArmXJ
I just bought the damn thing like 7 months ago and have had to waranty it twice already. The place was closed but i went to autozone and they tested it and said it was bad. So ill go up there in the am and get a new one. I got my spare mounted (broke my back) and a few parts loaded up! Also got my rear door that wouldnt open to open! And checked all my fluids.. Good thing cause my transfer case was low lol.
CF Veteran
Joined: Apr 2011
Posts: 2,080
Likes: 0
From: Dayton Ohio
Year: 1998 classic
Model: Cherokee
Engine: 4.0!!
huh? Why? lol I know its closed the 21st for some foot race lol. I have no where else to put the full spare... It was either roof or not bring it and ive Popped the tire off a rim before and had to use the spare. If i didnt bring it id get a flat but now that i have it i wont need it lol.
CF Veteran
Joined: Apr 2011
Posts: 2,080
Likes: 0
From: Dayton Ohio
Year: 1998 classic
Model: Cherokee
Engine: 4.0!!
I wouldnt have done it if it was on one of my bead lock rims lol. It wasnt bad because i lifted it and sat it on the rear tire then got a better grab and hucked it up there lol. Thanks for the offer for the alt Ken, I have two new ones sitting on the shelf too lol. I think its the battery though.
ok i got drivers side all back together but i cant get pass. lower
ball joint out im stuck. the press im using only has 3 sleeves 2 of them fit the top joint right but no the bottom
ball joint out im stuck. the press im using only has 3 sleeves 2 of them fit the top joint right but no the bottom
Originally Posted by LongArmXJ
huh? Why? lol I know its closed the 21st for some foot race lol. I have no where else to put the full spare... It was either roof or not bring it and ive Popped the tire off a rim before and had to use the spare. If i didnt bring it id get a flat but now that i have it i wont need it lol.
Originally Posted by dan99xj
ok i got drivers side all back together but i cant get pass. lower
ball joint out im stuck. the press im using only has 3 sleeves 2 of them fit the top joint right but no the bottom
ball joint out im stuck. the press im using only has 3 sleeves 2 of them fit the top joint right but no the bottom


