The 2000 should work fine in yours, However if you use the 2000 head it will crack eventually, (which is why I am doing my motor) The coil pack wont matter, just run your distributor (goes into the cam sensor hole) and your harness ect. should all work fine. but the exhaust ports on the head wont work with your exh. manifold...

It will have reconditioned rods, .20" over pistons, resurfaced and checked crank shaft. new bearings and t/chain set. block will be checked as well.

I was thinking about $350-400 depending on how much The bearings and t/chain kit end up costing... I need to get my motor swapped out then I'll get on this motor.

 

Hey Ryan when can I come over again and "helpout " haha

 

Idk how long ill be at it today, so let's see about next weekend...

 

Harbor freight has one

 

Its a great "folder"

 

Ya that Harbor freight bender ROCKs! I'll sell ya mine for 5 bucks!!! Lol

 

Can any other jeep bumpers directly bolt on the xj? Or would they need slight modification?

 

NvM, i figured it out. With a little search button.

 

Holy Crap everyone has new sweet sig's

 

Wait a Second....Was I the only person who noticed your in Moab but you checking CF? get on the trail sucka!!!! We shouldn't hear form Shawn S, Sean O and Jason D till ya post pic's!!!

 

Ran poison spider today it was a nice day 65 degrees

 

Go run 7mile and watch the sunset

 

Pics?

 

We have all the pic on the camera so we will take more with our phones tomarrow on flat iron mesa so we can load them

 

We missed the sunset we were at pasta joes
I almost made patato salad hill open open lmao it was close