Yep exact replacement! *** hats

 

yeah that sound good but I don't think I have the piece that makes the top axle side work I'm going to play with it tomorrow and I'll let you know thanks for the help tom and tristan I'll try to remember those names

 

Oh crap there is a Red Head in that pic...

 

tom did you pull that of the top of your head or did you have to refer to which ever book john is in

 

oh the 44, but it has disk break's it must be on a JK

 

Not yet. The arm I will be using came in the mail today. I have some different arms that I was going to use, but switched to this on after the full high steer thing went out the windo. I mocked it up to get the measurements today and sent them along to Derek's hookup to get the DOM cut and tapped. He is expecting those to be done tomorrow, so I should finally get it on there this weekend.

I measured my turning radius last week so I can do a comparison after. Between the XJ pitman arm and slightly lower-range Durango steering box, it is pretty sad right now

 

My bible. I actually looked it up a while ago, for some reason your username reminded me of the bible....

 

do you have these parts? looks like hte arms would go this way... Brackets side frame side... (putting bushings on body side, joints at the axle) http://www.rockkrawler.com/pages/cat...p?r_itemID=182

 

so you ran the welded in washer I take it? I hacked mine the heck out lol

 

That's the kit I remember.... Gen 1 tristen???

 

We got a fastnall too. I'm putting 4.5 inch leafs on bought this xj with blocks and flat leafs so had to make it right. I took out the puck it had and put 3.5 coil springs and shocks for a 4-6 inch lift from fat bobs up in Ogden. Got a buddy in tooele I'm picking up a long arm kit from saturday. Other than that intake TB spacer exhaust home made bumper hid lights and all the good tune up stuff with a used rig

 

lol, Well post up how it goes, I love cross over steering. interested to see what your thoughts are.

Advanced 4x4 in SLC made my arms for me on the spot (about 45 mins) they where 75$, just in case you ever need a replacement ect. will custom drill/taper them for any setup for no additional cost.

 

Nice! sounds like your on the right track, should be a good little wheeler!

 

thats the arms I have made my own brackets. just don't have the pieces to make that big fork on the middle one to make it fit the little ### bracket on the axle

 

Yes, the Gen two (I posted earlier was a 4 link..)