So I got givin a 79 ford with a 9 inch rear and I'm tryin to decide what the front is, it's got the raidious arm's where they a d44

 

most likely a 44 unless it's a F350.

 

F150 and I have a rear axle out of a 72 ford f250 camper special not positive what it is I know its big pm or text or call if interested 4three5 4six9 223one I can send you pics, can't figure out how to post them

 

Cast wedge 44 then....How much ya looking for the whole truck? I got a 86 I could do a SAS on......

 

Yeah the f150 is cast wedge, and the 72 is a two wheel drive or I'd be using those axles but hell shoot an offer if interested

 

Well here it's normally I'm driving around and start going down a hill in second coming up to a stop sign I push in the clutch and to shift to first and it just drops the rpms all the way down and I have to start it again once I stop.

 

I would say u need to adjust ur tps. While ur at it clean out the whole throttle body! If that doesnt solve it let us know & we will go from there...

Sold my swamps off ksl!

 

Well how do I get a stripped screw out of it? Tried getting the screws off the top and stripped the head bad

 

I'm going to attempt to rebuild my motor wish me good luck guys haha

 

If you can weld another bolt to that one I've had good luck with it. But I'm not sure what screw or bolt your talking about if that's possible for your case

 

It's the t20 screw on top of the throttle body to get the intake off

 

Have you tried using an easy out???

 

In that situation I'd probably drill and tap it to accept a new screw.

 

Ok I will look into that tomorrow

 

I am a bit confused on which screw. but vise grips have almost always worked for me. grab the outside and make it really tight then twist to pop it loose and walk it out from there, then get a new one. again might not be possible on this one... good luck