I can help u bro, actually bof of yas

 

I'll take all the help I can get. =)

 

Just gotta get it aligned and do the rear extended lines and she pretty much ready to go besides the 33s in a couple months also finish the quick discos up

 

axle u-joints or drive shaft ...It's an easy job either way

 

I assuming axle ujoint. When I turn the steering wheel all the way left, there is a groan from the driver side hub area when not under power. If given gas, there is no groan. It's the same on the passenger side but, not as loud.

Scott

 

If I was down town I could pull those for you in about 1 hour , however the job is straight forward ...I don't recall the size of the d30 hardware ,but there is only like 3 bolts holding the hub to the knuckle and 1 big nut holding the stub to the hub , and of course a few bols to things like the calipers , But the job is nothing to get scared of very straight forward ... I thinks you can do it .

 

Part of the problem I face is I have no workspace i.e. I live in an apartment plus, as far as tools go, I only have a basic wrench set.


Scott

 

Where do you live at

 

Ouch I live up here in the boonies ...and I got work tomorrow ...if I had more time I would bring tools as it is a job that can be done curb side .

 

Quebec and Evans/Illiff in Denver.

 

I've got work in the morning then going to be busy the rest of the day or I'd def cone help you out. I'm right off Buckley and Mexico majority of the time

 

I literally jus changed my ball joints the other day but have all the hardware to help u out. I too live in an apt but I have an overhead parking space. PM if u want to set it up

 

The hub bolts are a 13mm 12pt

 

do you remember the size of the big bolt on the stub/hub assemblies size .i think the calipers ar 10mm

 

Hub bolts are I believe 36mm? Maybe 32?