Installed a CB radio and antenna. then removed the plastic fender flares and trimmed her good, looks awesome!!!

 

[QUOTE=assetts91;2255030]Headlights went out when I was driving between three sheriff's last night.... Needless to say, ordered a putco wiring harness and autopal h4 housings![/

So your xj is operating, why haven't I seen you up at walker?

 

Did a drain and fill on my trans and t-case. Who would of known the transmission likes engine oil so much.

 

Got a transmission for 44.99 plus 27.00 for a year warranty at picknpull thank you half off day!

 

That is a major score, I wish I knew when the half off days are at my local jy. I went to 3 today to find very few xj's, which were all heavily picked over.

 

I installed a Detour Bumper Brow Lite Bar during our warm spell.

 

just got my xj today. did 5 hours worth of cleaning and found out im replacing my rear yoke tomorrow

 

Worked on my rear tri link build. Got all links mocked up, and ready to be Burnt in tomorrow.
To do list:
Burn in links,
Burn in axle side mounts
Remove frame side mount plates, burn in mounts
Reinstall frame mount plates burn those in,
Burn in coil mounts,
Finish up little things...
Take out and wheel!

 

welcome to the xj community. where the heck is Washougal?

 

Past camas. East of Vancouver.

 

ohhh ok thanks

 

went into portland got a new yoke. wires and everything to hook the speedo up. muffler and tail pipe. now time to get out and put it all on

 

i got my axle seals and pinion yoke seal all changed out, front axle is all good. no more leaks!

 

Installed and tested the new Aussie locker in my 8.25. Lovin it so far! Not hard by any means but crap I wish I would have just taken it to my friends with his lift.. And warmed up the gear oil, took me half as long to fill up the diff with fluid as it took me to install. Wish I would have taken pictures but my hands were oily and I was losing day light.

 

As long as it was within spec you shouldnt have any problems with it. I have one in my 8.25 as well and love it. Did you replace the side gear thrust washers?