My 99 8.25 axle yoke is messed up and I am wanting to replace it with the liberty 8.25 flange style adapter. Can i just remove the nut and then bolt the other adapter on? or do the bearings need to be preloaded so a certain spec, or will it mess with me ring and pinion mating surfaces at all? Once again its just a unbolt and bolt on. I just need to know if that is ok or is there going to be bad consequences just doing it that way?

 

wow............ no responses

 

just unbolt it and bolt it on just make a mental note how tight it was when you remove id