Okay, so i have been looking around here, and cant seem to find anything that sounds too close to my problem. When i am at a complete stop, and i go to put my jeep back into gear, it is hard to do it. I almost have to force it in. Stangely, this only happens it after it has been running for about 25-30 minutes. Any ideas?

 

are you stick shift

 

Clutch, through-out bearing, Shift forks or Shifter linkage it one of those items.

 

Try putting it into a higher gear then into 1st.

 

deleted

 

Clutch seems fine, but i have been wrong before...is there a way to test each of these to find what one?

 

ill try that out. if it goes smooth, does that mean synchros?

 

Typically indicates low gear oil or linkage problem. If not the clutch might not be disengaging all the way.

 

just checked gear oil so that ones ruled out. looks like someone may need a new clutch ha.

 

It might be a problem with the hydraulics side of the clutch... You might try flushing the system.

 

Does it get easier if your rolling slowly?

 

I would say linkage adjustment, throw out bearing issues or the Synchro arent meshing like they need to when you shift. Might need to service your gears.